Elsner Corlo Touch KNX 기술 사양 및 설치 지침 - 페이지 5
{카테고리_이름} Elsner Corlo Touch KNX에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsner Corlo Touch KNX 12 페이지. Display and touch switch
Elsner Corlo Touch KNX에 대해서도 마찬가지입니다: 기술 사양 및 설치 지침 (2 페이지)
페이지 인쇄
2.
Installation and start-up
2.1. Installation notes
Installation, testing, operational start-up and troubleshooting should
only be performed by an electrician.
CAUTION!
Live voltage!
There are unprotected live components inside the device.
•
National legal regulations are to be followed.
•
Ensure that all lines to be assembled are free of voltage and take
precautions against accidental switching on.
•
Do not use the device if it is damaged.
•
Take the device or system out of service and secure it against
unintentional use, if it can be assumed, that risk-free operation is no
longer guaranteed.
The device is only to be used for its intended purpose. Any improper modification or
failure to follow the operating instructions voids any and all warranty and guarantee
claims.
After unpacking the device, check immediately for any mechanical damages. If it has
been damaged in transport, inform the supplier immediately.
The device may only be used as a fixed-site installation; that means only when
assembled and after conclusion of all installation and operational start-up tasks and
only in the surroundings designated for it.
Elsner Elektronik is not liable for any changes in norms and standards which may occur
after publication of these operating instructions.
2.2. Installation
2.2.1. Assembly site and assembly preparations
The device must only be installed and operated in dry, indoor
spaces. Avoid condensation.
Avoid direct light (sunlight, lights) when choosing the assembly site. The proximity
sensor's function can be impaired by strong light sources.
Choose the assembly height based on the application in each case: When used as a
switch, the Corlo Touch KNX should be mounted 110 cm above ground level and
when used as an indicating and control display, at a conveniently legible height, say
150 cm.
Display Corlo Touch KNX • Status: 06.08.13 • Technical changes and errors reserved.
5
Installation and start-up