Datalogic GFC-800 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Datalogic GFC-800에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic GFC-800 2 페이지. Accessory
페이지 인쇄
The overall dimensions are provided in the figure below and can be used for proper
installation.
2
[0.10]
135
[5.31]
125
180
[4.91]
[7.09]
45
A
[1.77] N°4
9
[0.35] N°4
180
35
220
175
[7.09]
[1.38]
[8.66]
[6.89]
610
[24.02]
The following procedure describes how to mount the GFC-800.
1.
Prepare the DS8100A scanner to be inserted in the GFC-800 holding bracket. The
scanner should be oriented so that the output window is in front of the holding bracket.
Then, align the scanner mounting side to the holding bracket as indicated below:
Mounting Side
Output Window
Mounting Holes
3
[0.12]
50
670
[1.98]
[26.37]
A
mm
inch
Connector Panel
2.
Insert the scanner into to the GFC-800 holding bracket paying attention to the insertion
side (see step 1). Carefully push the scanner towards the internal rubber protection:
3
[0.12]
3.
Fix the scanner by tightening the two screws on the holding bracket side while keeping
it pushed towards the internal rubber protection. This will guarantee an hermetic
sealing:
4.
Mount the GFC-800 to the supporting frame using four bolts as indicated below:
5.
Connect the DS8100A scanner according to the procedures listed in the scanner
installation manual. Although the scanner is ready to read codes after installation,
reading performance can be optimized by setting some software configuration
parameters. For information on these procedures contact Datalogic.
Internal Rubber
Protection
Connector Panel
Mounting Screws
Bolts