cayken tools 916H 운영 매뉴얼 - 페이지 5

{카테고리_이름} cayken tools 916H에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. cayken tools 916H 8 페이지.

페이지 인쇄

Fix using expansion screw regular way, first, will guarantee that face and the

base of machine will be balanced , if have , it is high! Please use the spanner that

takes in machine attachment for low injustice,the 4 adjustment screws on

regulation base are balanced till base. After being fixed completely, machine

should guarantee that generator will not slide on rack . And will make efforts

around around pull to move pillar , will guarantee that when pillar is not around ,

sway side may use machine.

Pay attention: Our company suggests to use expansion bolt regular way to fix

vigorously, and the location of expansion screw lets egg to pillar direction to be

near is best. Since fixing consequence our company that not causes firmly , do not

undertake any duty.

Vertical upward drill hole, must ensure special turn water to obtain basin , gu-

ard against generator strictly cannot enter water. In working error any suspension,

open only to start machine road can. ensure to take the charge of machine fear st-

art former bit may turn freely.Is not blocked in hole.

FRICTION CLUTCH

Clutch carries out protection under high-strength mechanical overload

condition for operator, machine and bit. Please ensure clutch in a separation state

goes off work to do do not exceed 3-4 second, because it will cause temperature

rise quickly and causes wear for friction flat that time passes length.

MASTER SWITCH AND OVERLOAD PROTECTIVE DEVICE

After pressing switch, machine ( soft start switch ) starts smoothly.If machine

is overload, its electron protects switch, will remind operator machine to be

overload with exceptional fluctuation. If load does not be reduced , after some

seconds of clocks, switch is closed voluntarily. Start again if remove load, machine

will again start smoothly. When start machine again is former, ensure bit may turn

freely is not blocked in drill hole. It will even burn out for that generator causes

serious infringement if this machine highest compression is higher than 260 V for

260 V. When using generator to supply power , must notice that voltage peak value

cannot be higher than 260 V.

GEAR SPEED ADJUSTMENT

Ordinary gear speed adjustment

3 files

2 files

Oil soaks money gear speed adjustment

3 files

2 files

To improve the efficiency of drilling, some machines have 3 type gear speed chang-

es. In it is high to divide , high speed files ( the day files ) apply to little bit and more

soft material to rush , fast files ( M files ) apply to in bit and more hard material; The

files of low speed ( L files ) apply to big bit and hard material.。

Machine turns under stoping the state that turns or stops soon to move group Niu

change files.

Machine must want to shift gear to position when shifting gear , if occur main shaft

after start,it does not turn or have tooth sound to explain that files position does

not hang to position , must close switch at once, and turn again move knob to the

position that needs files at the same time round trip turns main shaft ( hang files

easily ), have obvious put into gear to block until position.

Must close mains switch at once, round trip turns mainshaft to at the same time

turn to move knob. Machine is operating at full speed, load or card please don't

change files when living.

L is the files of low speed, H is high speed files, M is the files of middling speed

( 3 files types), graphic representation is the files of low speed, spin along hour

hand if by the files of low speed, turning high speed files knob, otherwise

counter-clockwise.