Dust Free 04966MV 설치 및 운영 매뉴얼 - 페이지 7

{카테고리_이름} Dust Free 04966MV에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dust Free 04966MV 8 페이지. Ultraviolet light systems

페이지 인쇄

BIO-FIGHTER

NOMAD, NOMAD 2 INSTALLATION & OPERATION MANUAL

TROUBLESHOOTING

Maintenance and troubleshooting should be

performed by a qualified technician.

Device fails to operate.

1. Check that device is connected to proper

power.

2. Check that fuse is in good working order.

Replace with fuse if necessary.

3. Check that ballast is receiving correct

power. Replace ballast if necessary.

4. Check continuity of lamp filaments.

(Replace lamp if necessary.)

5. Check that wires are properly connected to

lamp and ballast.

6. Check that lamp is properly connected to

lamp receptacle.

FUSE REPLACEMENT

1. Disconnect power.

2. Unscrew the knob marked "Fuse" and

remove fuse.

3. Install new fuse and screw knob back in

place. Only use a 250V/3 amp fuse.

4. Reconnect power.

WARNING

Burn Hazard.

During replacement, allow lamps to cool 10 minutes

before removing them. Personal injury may result.

WARNING

Mercury Hazard. Do Not Break.

Each UV-C lamp contains a small amount of Mercury.

May cause redness or irritation. Use proper disposal

techniques in case of breakage.

LAMP REPLACEMENT(Annually)

The lamp should be replaced annually even if

it appears to be operating normally. UV-C

energy production diminishes over time.

1. Obtain the correct replacement lamp for

your model.

2. Disconnect power to the equipment. Allow

lamp to cool 10 minutes before touching.

3. Remove old lamp and install new lamp.

See page 5.

4. Reconnect power. For Nomad 2 make sure

power switch is in the "ON" position.

5. Use viewport to verify operation.

LAMP DISPOSAL

Dispose of your spent UV-C lamps at your

local recycling center. You may also send your

spent lamps in the same container you

received your replacement lamps to:

Dust Free® Lamp Reclamation

1112 Industrial Drive

Royse City, TX 75189

PROPER CLEAN-UP TECHNIQUE IN CASE OF

LAMP BREAKAGE

Wear protective gloves, eyewear and mask.

●

Sweep the broken glass and debris into a plastic

●

bag, seal the bag, and dispose of properly.

Contact your local waste management office for

proper disposal.

Do not use a vacuum cleaner. Do not

●

incinerate.

Replacement Parts

UV-C Lamp - 9"

UV-C Lamp - 16"

Ballast - Nomad - 9"/16", Nomad II - 9"

Ballast - Nomad II - 16"

Remote Safety Interlock

Fuseholder

Fuse

Lighted On/Off Switch Nomad II 120V/230V

For information on the dealer in your area call: 1-972-635-9565.

Visit us at http://www.dustfree.com

Part No.

06035

06036

06149

06167

06150

212225-00

750-0108-001

750-0026-002