Datalogic GRYPHON Mx30 빠른 참조 매뉴얼 - 페이지 9

{카테고리_이름} Datalogic GRYPHON Mx30에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic GRYPHON Mx30 18 페이지.

USING

MULTIPLE

CRADLE

If you want to use several readers associated with the same cradle, you must

first Bind the cradle with one of the readers (see previously described

configuration procedure).

Successive readers can be associated with the same cradle by following the

configuration procedure substituting the Bind command with Join.

The green LED on the Gryphon™ M will blink: the reader is ready to be

positioned onto the cradle. Complete step 6.

CAUTION

GRYPHON™ M DEFAULT CONFIGURATION

DATA FORMAT

code identifier disabled (enabled for POS terminals), field adjustment

disabled, code length tx not transmitted, character replacement disabled,

address stamping disabled; address delimiter disabled,

POWER SAVE

scan rate 270 scans/s; sleep state/USB suspend disabled, enter sleep

timeout = 0.6 sec

READING PARAMETERS

hand-held operation = hardware trigger, stand operation = automatic, trigger

active level, no timeout, Flash On = 1 sec, Flash Off = 0.6 sec, one read per

cycle, safety time 0.5 sec, beeper intensity high, tone 2, beeper type

monotone, beeper length short, low PDF decoding recognition intensity,

good read spot duration medium, automatic operation aiming light enabled.

DECODING PARAMETERS

ink spread enabled, overflow control enabled, interdigit control enabled,

Puzzle Solver™ disabled, decoding safety = one read

Ì$+RN1$-NÎ

If the cradle is not Bound to a reader, its address assumes

a random value, which can cause conflicts and malfunctions

to other cradles within its range.

READERS

Join

GRYPHON™ MX30

WITH

SAME