Dust Right Vortex 사용자 지침 - 페이지 4
{카테고리_이름} Dust Right Vortex에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dust Right Vortex 4 페이지.
Flexform
™
hose
Shop
vac
Fig. 5
6. Insert one end of your existing shop vacuum hose in
the open Vortex
port, and attach the other end to your
™
power tool dust port or a shop cleanup handle/wand.
Fig. 5.
Tip: Some shop vac hose fittings are slightly under
2
⁄
". In this case a couple wraps of tape will make a
1
4
tighter fit. Fig. 6.
7. For best results, do not fill past the fill line on the
Vortex
™
bucket. Fig. 7.
Dust Right Vortex
Too much dust and dirt is getting to your
vacuum's filter:
1. Small amounts of dust and fine dust will
appear in your vacuum's filter. This is normal.
2. Check for air leaks. Even a small leak can
affect performance.
3. Check to make sure debris has not collected
above the fill line in the canister.
Suction power seems lower than it should:
1. Check for clogs in your hoses.
2. Make sure you start with a clean filter.
Important Safety Instructions
1. Never use the Dust Right Vortex
combustible liquids, gases, or other related materials as it can
cause injury or death due to fire or explosion.
2. Never vacuum burning or smoking materials such as cigarettes,
matches, or hot ash. Smoldering waste may later burst into flames.
3. Never vacuum toxic materials deemed to be carcinogenic,
combustible, or in any way hazardous. Materials of this type
include asbestos, arsenic, barium, beryllium, lead, and pesticides.
This is an incomplete list and it is the user's responsibility to
consult with hazardous waste professionals if they are in doubt
about materials they wish to evacuate.
4. Never leave wood dust in a building or vehicle where it may
become hazardous if left unchecked.
40530
3
Existing shop vac hose
or 2
⁄
" shop hose
1
2
Vortex
canister
Troubleshooting
™
™
to vacuum flammable or
Power tool
™
Shop vac hose
Fig. 6
Fig. 7
5. Always dispose of waste in a fire safe area.
6. The Dust Right Vortex
play on or near the system. Pay close attention when used by
or near children.
7. Pay close attention to the fill line on your Dust Right Vortex
sure to empty the canister before it accumulates to a level above
the fill line. Optimum operation can be achieved with regular
disposal of waste in the methods prescribed in this manual.
8. Do not use in any other manner than what is described in
this manual.
Tape
Fill line
is not a toy. Do not allow children to
™
RTD10000 801
Distributed by Rockler Companies, Inc.
©2011 Rockler Woodworking and Hardware
Clean up
wand
™
. Be
Rev
Rev 01/11
Patent Pending