elsner elektronik KNX RW Series 기술 사양 및 설치 지침 - 페이지 3
{카테고리_이름} elsner elektronik KNX RW Series에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. elsner elektronik KNX RW Series 11 페이지. Rain/wind sensor
페이지 인쇄
BCU type
PEI type
Group addresses
Allocations
Commmunication objects
Heating rain sensor
Measurement range wind
Resolution (wind)
Accuracy (wind)
The product conforms with the provisions of EC guidelines
•
EMC Directive 2004/108/EC
•
Low Voltage Directive 2006/95/EC
The following standards and/or technical specifications have been applied:
•
EN 50491-5-1: 2010
•
EN 50491-5-2: 2011
2.
Installation and commissioning
2.1. Installation notes
Installation, testing, operational start-up and troubleshooting should
only be performed by an electrician.
DANGER!
Risk to life from live voltage (mains voltage)!
There are unprotected live components within the device.
•
National legal regulations are to be followed.
•
Ensure that all lines to be assembled are free of voltage and take
precautions against accidental switching on.
•
Do not use the device if it is damaged.
•
Take the device or system out of service and secure it against
unintentional use, if it can be assumed, that risk-free operation is no
longer guaranteed.
The device is only to be used for its intended purpose. Any improper modification or
failure to follow the operating instructions voids any and all warranty and guarantee
claims.
After unpacking the device, check it immediately for possible mechanical damage. If it
has been damaged in transport, inform the supplier immediately.
Rain/Wind Sensor KNX RW • Status: 19.08.2013 • Technical changes reserved. Errors reserved.
3
Own micro controller
0
max. 254
max. 255
81
approx. 1,2 W (230 V and 24 V)
0...70 m/s
<10% of the measured value
±25% at 0...15m/s, at an angle of attack of 45°,
pole mounting
Installation and commissioning