elsner elektronik TH PF 기술 사양 및 설치 지침 - 페이지 4

{카테고리_이름} elsner elektronik TH PF에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. elsner elektronik TH PF 11 페이지. Indoor sensor and ventilation control

actual room temperature during a 2 hours heating period. Additionally, the

temperature can be adjusted in the basic settings menu.

Installation and start-up

Installation, testing, operational start-up and troubleshooting should

only be performed by an electrician.

CAUTION!

Live voltage!

There are unprotected live components inside the device.

•

National legal regulations are to be followed.

•

Ensure that all lines to be assembled are free of voltage and take

precautions against accidental switching on.

•

Do not use the device if it is damaged.

•

Take the device or system out of service and secure it against

unintentional use, if it can be assumed, that risk-free operation is no

longer guaranteed.

The device is only to be used for its intended purpose. Any improper modification or

failure to follow the operating instructions voids any and all warranty and guarantee

claims.

After unpacking the device, check it immediately for possible mechanical damage. If it

has been damaged in transport, inform the supplier immediately.

The device may only be used as a fixed-site installation; that means only when

assembled and after conclusion of all installation and operational start-up tasks and

only in the surroundings designated for it.

Elsner Elektronik is not liable for any changes in norms and standards which may occur

after publication of these operating instructions.

The Ventilation Controls TH PF(-U) is installed flush to the wall surface in a junction

box (R 60 mm, 42 mm deep).

May be installed and operated in dry interior rooms only.

Avoid condensation.

When selecting an installation location, please ensure that the measurement results

are affected as little as possible by external influences. Possible sources of interference

include:

•

Direct sunlight

Ventilation Controls TH PF(-U)

Status: 19.04.2016 • Technical Changes and Errors excepted.

Installation and start-up