CB ELECTRONICS TMC-1 설정 매뉴얼 - 페이지 8
{카테고리_이름} CB ELECTRONICS TMC-1에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CB ELECTRONICS TMC-1 14 페이지. Connecting with yamaha mmp1
CB ELECTRONICS TMC-1에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지)
페이지 인쇄Setting up the system
To set the TMC-1 operation mode
Press the [Page] and [Select] keys simultaneously to display the Select Page.
1.
Press User Key 8 "Setup" to display the Setup Menu.
2.
While holding down the [Select] key, press User key 4 "→" to display the Adv Menu
3.
24 - MMP1 Device Emulation page.
Use the User Keys 3 "↑" and 7 "↓" to select the "MMP1 Compliant" mode.
4.
To connect TMC-1 to MMP1
If you want to connect the TMC-1 to the MMP1 using IP addresses other than Auto IP, see "To
set IP addresses" on page 9 to set the IP addresses according to your system before
connecting them.
1. Press the [Page] and [Select] keys simultaneously to display the Select Page.
Press User Key 6 "E-Net" to display the Discovery page.
2.
All the devices in the same network will be shown on the Discovery page. If no devices are
detected, press User Key 5 "Re-Scan" to start the detection again.
8