Datalogic QuickScan QS6500BT 빠른 참조 매뉴얼 - 페이지 8

{카테고리_이름} Datalogic QuickScan QS6500BT에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic QuickScan QS6500BT 17 페이지. Handheld bar code scanner

8. Place the linear imager in the Base Station and verify the

charge LED is flashing. After five minutes, the scanner will

have sufficient charge to begin reading labels. A full charge

will take 2.5 hours.

9. Press and hold the link button on the bottom of the Base

Station for three seconds. This will ensure that any other

imager link to the Base Station will be broken. Upon unlink-

ing, the Base Station will sound a short beep, followed by

two longer beeps, accompanied by a flashing amber LED.

10.Scan the bar code located on the label applied to the back

face of the Base Station. This will "link" the linear imager to

the Base Station. Upon successful link (which can take a few

seconds), the imager will sound a low-to-high pitched beep.

11.To verify scanning operation, point the linear imager at a bar

code and pull the trigger. The linear imager should emit a

beep indicating that the label has been scanned and transmit-

ted to the Base Station successfully.

The linear imager installation is complete.

NOTE

A momentary press of the link button can be used to later

verify a link between the imager and Base Station. A good

link is indicated by six short beeps. The Base Statioin notes

an unlinked situation by slowly flashing an amber LED.

QuickScan

QS6500BT