CB2 LINEAR 조립 지침 - 페이지 5
{카테고리_이름} CB2 LINEAR에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CB2 LINEAR 5 페이지. Tall chest
CB2 LINEAR에 대해서도 마찬가지입니다: 조립 지침 (4 페이지), 조립 지침 매뉴얼 (11 페이지)
페이지 인쇄
linear
LOW DRESSER
safety mounting instructions
For added safety and stability, it is recommended that
the wall mounting hardware be installed. For safe
mounting, it is essential to use wall anchors
appropriate to your wall type (i.e. plaster, drywall,
concrete, etc.). Mount to wood studs whenever
possible.
A) Attach 1 wall bracket to top of unit as shown,
using 2 small screws per bracket.
B) Determine the final location of unit. Mark position
on the wall, approximately 2" below the bracket
mounted to the back of the cabinet.
C) Drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller
in diameter than the anchor. Gently tap the plastic
anchor until the flange of the anchor is flush with the
wall.
D) Attach the wall bracket to the wall by inserting 2
large screws through the wall bracket and into the
wall anchor in the wall.
E) Place the unit so the wall bracket on the back
edge is aligned with the wall bracket.
F) Lace one end of the wall strap through both
brackets, and into the other end of the strap.
G) Pull the strap tightly until secure. Repeat steps for
remaining brackets and wall strap.
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware store.
Made in Vietnam - r05
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
wall
strap
plastic
A
anchor
small
screw
F
wall
large
D
bracket
screw
C
wall
bracket
Page 5 of 5