CB2 SAGA 조립 지침 - 페이지 5

{카테고리_이름} CB2 SAGA에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CB2 SAGA 5 페이지. Credenza

saga

CREDENZA

optional wall mounting assembly

NOTE: If you are unsure about your wall type or what mounting

method you should use, consult a qualified professional or your

local hardware store.

For added safety and stability, it is recommended that the wall

mounting hardware be installed. For safe mounting, it is essential to

use wall anchors appropriate to your wall type (i.e. plaster, drywall,

concrete, etc.). Mount to wood studs whenever possible.

A) Attach 2 mounting brackets to top of unit using 2 small screws

per bracket.

B) Determine the final location of unit. Mark position on the wall,

approximately 2" below the mounting bracket mounted to the back of

the unit.

C) Drill a hole in the wall stud. If the wall stud is not available, drill a

hole in the wall that is slightly smaller in diameter than the anchor.

Gently tap the plastic anchor until the flange of the anchor is flush

with the wall.

D) Attach 2 mounting brackets to the wall by inserting 2 large

screws through each mounting bracket and into the wall anchor in

the wall.

E) Place the unit so the mounting brackets on the back edge are

aligned with the wall brackets.

F) Lace one end of the wall strap through both brackets, and into the

other end of the strap.

G) Pull the strap tightly until secure.

Wall mounting assembly is now complete.

Made in Vietnam - r08

WALL

Customer Service 800.606.6252 | Latest instructions available at www.cb2.com

cleaning & care

Clean surfaces with a dry or damp soft

cloth. Do not use abrasive cleaners. Do

not use furniture wax or polish as the unit is

finished with a protective clear lacquer. It is

recommended to use coasters to protect

surface from heat and water.

This credenza is suitable to hold and not

exceed a 14-16 inch conventional TV and a

30-40 inch flat screen TV evenly distributed.

Page 5 of 5