Datalogic S70 매뉴얼 - 페이지 3

{카테고리_이름} Datalogic S70에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic S70 18 페이지. Advanced sensor with dual digital displays for use with plastic and glass fiber optic assemblies
Datalogic S70에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지)

페이지 인쇄

TOP PANEL INTERFACE

Opening the dust cover provides access to the top panel interface. The top panel interface consists of the RUN/PRG/ADJ

mode switch, LO/DO switch, +/SET/- Navigation key, dual red/green digital displays, and output LED.

RUN/PRG/ADJ Mode Switch

The RUN/PRG/ADJ mode switch puts the sensor in RUN, PRG (Program), or ADJ (Adjust) mode.

RUN mode allows the sensor to operate normally and prevents unintentional programming changes via

the +/SET/- button. PRG mode allows the sensor to be programmed through the display driven

programming menu (see Program Mode below).

ADJ mode allows the user to perform Expert TEACH/SET methods and Manual Adjust (see Adjust

Mode below).

LO/DO Switch

The LO/DO switch is used to select Light Operate or Dark Operate mode. In Light Operate mode, the

output is ON when the sensing condition is above the threshold (for Window SET, the output is ON

when the sensing condition is inside the window). In Dark Operate mode, the output is ON when the

sensing condition is below the threshold (for Window SET, the output is ON when the sensing condition

is outside the window).

+/SET/- Navigation key

The +/SET/- Navigation key is a 3-way button. The +/- positions are engaged by rocking the button left/

right.

The SET position is engaged by clicking down the button while the rocker is in the middle position. All

three button positions are used during PRG mode to navigate the display driven programming menu.

During ADJ mode, SET is used to perform TEACH/SET methods and +/- are used to manually adjust

the threshold(s). The Navigation key is disabled during RUN mode, except when using Window SET,

see

Window SET.

Red/Green Digital Displays

During RUN and ADJ mode, the Red display shows the signal level and the Green display shows the

threshold.

During PRG mode, both displays are used to navigate the display driven programming menu.

Output LED

The output LED provides a visible indication when the output is activated.

Remote Input / IO-Link

For more information about how to perform TEACH/SET methods, to program the sensor remotely,

or to interface with the sensor via IO-Link, see the www.datalogic.com.

Run Mode

Run mode allows the sensor to operate normally and prevents unintentional programming changes.

The +/SET/- Navigation key is disabled during RUN mode, except when using Window SET, see

Window

SET.