DUSTER 00301 운영 및 유지보수 매뉴얼 - 페이지 3

{카테고리_이름} DUSTER 00301에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DUSTER 00301 8 페이지. Mobile prep station

Step 1: Uncrate the Duster 3000 Downdraft

wooden panels with a #2 Philips screwdriver or power tool.

Remove box with filters and roll the Duster 3000 Downdraft off the skid.

Remove the plastic bag.

Remove gray PVC support from the rear of the Duster 3000 Downdraft and

insert into the support holder located in the center of the front panel.

Step 2: Install the Intake Filters

Remove the three intake filters from the box.

Insert the intake filters in front of the preinstalled carbon filters. Make sure the

black Velcro pull tabs attached to the carbon filters are not pinched between

the filters.

Secure the intake filters with the Velcro tabs located on both sides of each

filter.

Proper sealing of the intake filters will prevent dirty air from bypassing the metal

framed intake filters. Improper sealing will plug up the carbon filters and the

Viledon top pocket filter.

Step 3: Plug in the Duster 3000 Downdraft

Locate an electrical outlet that is capable of handling the Duster 3000

Downdraft:

o 110-120Vac, 12A, 60Hz, 1Ph

Make sure your electrical power panel is capable of handling a 12A load in

addition to your current usage. Overloading your panel may not allow the

Duster 3000 Downdraft to function correctly or to its full airflow capacity.

Plug in the Duster 3000 Downdraft and roll it into position.

Correct

Incorrect