ADE EHR1 운영 매뉴얼 - 페이지 9

{카테고리_이름} ADE EHR1에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE EHR1 20 페이지. Platform scale

When using a mobile scale the following aspects are to mind:

 Place the scale on a solid and level surface.

 Adjust the scale in the way that all feet are contact plated.

 If there is a bubble level existing justify the scale according, apart from that please apply a

water level.

 Connect the indicator with the scale platform by using the therefore intended socket plug.

Should the scale be transported or stored a re-positioning as just described is on demand.

Choose the unit of weight (kg/oz/lb) by pressing the „U-key" (Units). The corresponding LCD-

status indication for the actual unit of weight is flashing.

To switch on the scale press „ON/OFF/

takes place. This process ends with zero indication. Now the scale is ready for operation. At

zero indication, the scale can be loaded. After standstill the weight is direct readable.

Wait until the scale found standstill. By the use of ON/OFF/

will compensate and set on zero before the actual weighing procedure.

With the assistance of this function, you are able to weigh the loading together with other

objects (e.g. a bowl) without an adverse effect to the loading weight induced by the weight of

an object.

Set the scale to zero - if needed by pressing the „ON/OFF/

indicates Zero ◄.

Place the objects which are to tare on the weighing platform (e.g. bowl or the like).

Press Tare-key to engender the zero status. Now on the display appears the indication

`0.00´ and the Tare ◄ symbol is visible.

Put the weighing load into the bowl.

The readable weight on the display is the net weight of the weighing load.

If the tare value stored at the beginning remains the same, you are able to weigh now further

loadings. However, the scale may not switched-off between the weighing procedures because

in that case the tare-memory becomes resetting. The scale automatically subtracts the stored

weight and the net weight of the loading where indicated. If you intend to revise or delete the

stored value, take off all loadings from the scale and press again the Tare-key.

EHR_EHQ-210517-Rev009-UM-en

Practise of the scale

-key". After switch on, automatically a function test

the accuracy of measurement

key". The display