Datamaster T0046 사용자 설명서 - 페이지 9
{카테고리_이름} Datamaster T0046에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamaster T0046 19 페이지. Professional lan cable tester
페이지 인쇄®
Datamaster
T0046 Professional LAN Cable Tester – User Guide
4
MODE SELECTION
Use the
UP /DOWN NAVIGATION
the five operating modes shown on the main menu
screen (shown opposite)
OR
Press one of the five blue coloured
Buttons.
5
LAN MODE - LOOPBACK
The Loopback Mode is capable of testing for the following faults:
•
Open circuit
•
Short circuit
•
Crossed wires
•
Split wires
Enter LAN Mode from either the main menu on the screen or by pressing the blue coloured
LAN
button.
Connect the cable between the MAIN and LOOPBACK
sockets as shown in the diagram opposite.
Press the
TEST
The display will indicate a PASS and the type of cable
connected if there is no fault.
If there is a FAIL due to a open-circuit fault, the distance to
the fault will be displayed.
Failures due to SHORT / SPLIT / CROSS problems will
have the applicable wire pair(s) shown).
TEST RESULTS
If the cable being tested was not faulty, the display will show the type of cable (FTP or UTP)
the word PASS and the word LOOP (indicating the test was performed in Loopback Mode. An
FTP cable will also show a wire 0 for the shield connection in addition to the 1 – 8 data wires.
The following screen-shots show the initial and the result screens for a non-faulty FTP cable.
keys to select one of
Mode Selection
button.
Page 5