CBT Supply FIK-19 설치 매뉴얼 - 페이지 7

{카테고리_이름} CBT Supply FIK-19에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CBT Supply FIK-19 16 페이지. Flipit kit generation ii

STEP 3 -

Drill Corner

Starting Holes

STEP 4 -

Saw the Hole for

flipIT

flipIT Tech Line: 800 770-7042

To make holes for starting your jig saw cut, use a 3/8" drill bit, place the point of the bit at the

corner mark and drill completely through the surface top. Repeat this step for each corner.

Place the jigsaw at the cor ner marking. Remove the layout line with the kerf of the saw cut for

a factory fit. You must have the skill to saw a straight line within the toler ance of the width of

the saw blade. Saw from corner hole to cor ner hole. Remove the remains of the paper tem-

plate when this step is finished.