DutchCrafters Poly Octagon Walk-In Table 조립 지침

{카테고리_이름} DutchCrafters Poly Octagon Walk-In Table에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DutchCrafters Poly Octagon Walk-In Table 2 페이지.

페이지 인쇄

Assembly Instructions for Poly Octagon Walk-In Table

Tools Needed:

Power drill or screwdriver

#2 Square Drive Bit

Lay the table tops upside down. Place the aluminum strips along the crosspieces attached to the table

tops. Make sure that the tops are aligned correctly then attach the aluminum strips with six ¾" screws in

each strip. (See photo 1.) Now attach the small poly blocks directly over the splice in the tops along the

outside crosspieces. Attach with 4- 1½" screws in each block. (See photo 2.)

Place the 4 support strips between the lines on the table crosspieces. The 42" strips belong on the outside

& the 33" strips on the inside. Attach with 6 — 2½" screws in the 42" strips and 4 screws in the 33" strips.

(See photo 3.)

Assemble the 4 bench legs. Take two leg supports and attach to a bench bottom. Put two 2½" screws

in the predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See

photo 4.)

Predrilled

holes in leg

supports

belong at

this end

Unfold a table leg assembly & place upside down on a table. (See photo 5.) Take a bench top & place

upside down with the center 2x2 between the 2x4 table leg support beams. Attach with two 2½" screws

on each side (See photos 5 and 6

Hardware:

88 - 2½" screws

8 - 1½" screws

24 - ¾" screws

4 - 36" aluminum strips

2 - 33" support strips

2 - 42" support strips

2 - small poly blocks

photo 1

photo 4

Parts List:

Table Top—2 pieces

Table Leg Assemblies—2 pieces

Bench Tops—4 pieces

1"x5½"x14½" Bench Leg Supports—8 pieces

1"x5½"x32" Bench Bottoms—4 pieces

Step 1

photo 2

Step 2

Step 3

photo 5

Step 4

*Keep 2x2 even with leg supports*

photo 5

photo 3

photo 6