Datamax H-Class 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Datamax H-Class에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax H-Class 12 페이지. Cutter option
Datamax H-Class에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 매뉴얼 (14 페이지), 매뉴얼 (10 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

F) Press the TEST Button then use the UP / DOWN Buttons to select the PRINT QUALITY LABEL or

the TEST LABEL. Set a quantity of labels to print and then press the ENTER Key. After printing

stops, carefully examine the labels for evidence of ribbon wrinkling (i.e., irregular diagonal voids that

extend through printed areas). Proceed according to your examinations:



If no evidence of wrinkling is present on the labels, press the CANCEL Key to stop printing and

complete the procedure; or,



If evidence of wrinkling is present, enter the Test Menu again and reselect the PRINT QUALITY

LABEL or the TEST LABEL. Set a quantity of labels to print and press the ENTER Key. Slightly

loosen the Ribbon Shield Screws then slightly readjust the Ribbon Shield to eliminate the latent

wrinkling. When finished, press the CANCEL Key to stop printing and complete the procedure.

The printer should now be ready for use in thermal transfer mode; however, if you are still experiencing

problems with the installation or application of this option, refer to the troubleshooting guide below.

Troubleshooting

The following table covers common installation and use problems.

If experiencing this problem...

'RIBBON FAULT' is indicated on the

printer's display panel:

Used ribbon is not being wound by

the Take-Up Hub:

Try this solution...

Ensure that ribbon is correctly installed and that the

printhead is latched; see the Loading Diagrams on the

printer's cover or in the Operator's Manual.

Check the ribbon hubs for obstructions that may be

inhibiting movement.

Ensure that the ribbon core fits snugly on the Supply Hub.



Ensure that the media is not slipping under the ribbon

(usually caused by an incorrect ribbon and media

combination); see Selecting Media and Ribbon, below.

Ensure that the leader has been correctly wound and

secured to the Take-Up Hub.