Datamax I-Class Mark II 설치 및 사용 설명서 - 페이지 3

{카테고리_이름} Datamax I-Class Mark II에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax I-Class Mark II 12 페이지. General purpose input output (gpio) option
Datamax I-Class Mark II에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

Overview

This document describes the installation and use of the General Purpose Input Output

(GPIO) option for the I-Class Mark II printer. Follow the steps to begin installing/using the

option.

For safety and to avoid equipment damage, turn OFF the power switch and

unplug the AC power cord from the printer before starting this installation.

CAUTION

Contents

This kit contains the following items:

 GPIO Circuit Card Assembly

 Standoff, 6mm Hex (2)

 Locking Nut, 5.5mm (2)

Tools Required

To install this option, you will need:

Philips screwdriver



5mm Hex Driver



5.5mm Hex Driver



6mm Hex Driver



Additional Requirements

Depending on your application, you may need the following hardware to interface the card:

Cable - DB15 Male connector (e.g., StarTech C15PCM) with shielded cabling.

