Datamax M-Class Mark II 매뉴얼 - 페이지 4
{카테고리_이름} Datamax M-Class Mark II에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax M-Class Mark II 6 페이지. Rfid option
Datamax M-Class Mark II에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (4 페이지), 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (8 페이지)
페이지 인쇄
Step 2: Installing the Cutter
Position the Cutter for mounting on the front of
the printer.
Tighten the Mounting Screw to secure the
mechanism to the printer.
This completes the installation process.
Proceed to Loading Media.
Loading Media
Before proceeding, ensure that the free end of the media has a clean, straight edge.
Route the media through the printer (see the
Operator's Manual for more information) and then
out through the Cutter's Opening, as shown. Close
and latch the printhead mechanism.
Close the cover.
Plug in and turn 'On' the printer.
Press the FEED Button to align the label's position.
Setup and Configuration
The Cutter is plug and play; no setup or configuration is necessary. When the power is applied, the Cutter
blade will cycle, indicating that the printer has automatically sensed and enabled the Cutter for operation.
Note: The operation of the Cutter is also controlled via software commands from the host. Be sure that your
software program is properly configured for the cutter and the desired label size.
Cutter
Mounting Screw
Opening
2