Datamax M-Class Mark II 매뉴얼 - 페이지 6

{카테고리_이름} Datamax M-Class Mark II에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax M-Class Mark II 10 페이지. Rfid option
Datamax M-Class Mark II에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (8 페이지)

페이지 인쇄

 Ensure that the Leveling Cam is

loose, and then close and latch the

Printhead Assembly.

 While pushing down on the

Printhead Assembly, as shown, pull

down on the Side Plate and tighten

the Screw.

Verify Latch Operation:

- Open and close the printhead assembly, verify that the latch is fully engaged. If you are unable to get

the printhead to latch, the side plate is too low.

- Pressing down on the printhead assembly should not cause the latch to loosen or reveal any gap at the

latch point. If there is a gap or movement in the latch then the side plate is too high.

- Print some sample labels. If degraded print quality or ribbon tracking problems are observed then the

side plate is not positioned correctly.

Step 3: Installing the Peel & Present Mechanism

 Position the Peel and Present Mechanism

for mounting on the front of the printer.

 Tighten the Mounting Screw to secure

the mechanism to the printer.

This completes the installation process.

Proceed to Loading Media to begin use.

Mounting Screw

Peel and Present Mechanism

Printhead Assembly

Leveling Cam

Screw

Side Plate