Datamax I-Class 사용자 설명서 - 페이지 10

{카테고리_이름} Datamax I-Class에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax I-Class 15 페이지. Present sensor option
Datamax I-Class에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄

6) While watching the 'Scan Count' in the Display Panel, slowly tilt the Scanner forward (toward the

Ribbon Shield) until the numbers increment continuously and rapidly (also, the green Indicator Light

on the Scanner will illuminate). This is the optimum reading position.

Display Panel

Scanner

7) Carefully tighten both of the Mounting Bracket Screws. (Ensure that the 'Scan Count' in the Display

Panel is still incrementing rapidly.) Unlock the printhead latch, remove the print quality label and

reinstall your operating media.

8) Using the printer's front panel, exit the 'ALIGNMENT TEST' by repeatedly pressing the ESC Key

(see the I-Class Operator's Manual for menu system details). With the printer at 'READY,' run a

batch of live labels to test the alignment. If necessary, repeat the procedure or, if problems persist,

consult the Troubleshooting section.

This completes the Alignment procedure.

Troubleshooting

This unit, a Class 1 LED Product per IEC 825-1 (1997) w ith power up to 15 mW in a 0.1 ms pulse at

635-670 nm, contains no user serviceable parts. A ll product service must be performed by Datamax-

O'Neil. Opening the Scanner will void the warranty and could expose the operator to LED light.

CAUTION

The most common reasons and solutions for Scanner Faults are listed below:

Mounting Bracket Screws

Indicator Light

Ribbon Shield