Datapath HLink-Optical 사용자 설명서 - 페이지 8

{카테고리_이름} Datapath HLink-Optical에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath HLink-Optical 13 페이지. Pci express optical expansion link

Inserting and Removing Cables

The ExCables-Optical should be inserted firmly into the connector on the HLink and SLink- Optical cards.

The correct way to insert the cable is to have the manufacturers label facing the card as shown in Fig. 6.

The rectangular connector needs to be fully inserted into the card (Fig. 7) until a definite click can be felt.

This locks the cable in place. Failure to lock the connector in place can result in the ExCable-Optical

becoming separated from the card and the link between chassis being lost.

To remove the connector gently pull the ring pull tab to unlock the connector from the card then slide the

connector out fully.

Normal fibre handling precautions should be observed to avoid tight loops or kinks in the

ExCable-Optical. Bend radii below 75mm are not recommended and may result in fibre breakage.

Fig. 6

Fig. 7

Fig. 8