Datapath VisionAV 매뉴얼 - 페이지 2
{카테고리_이름} Datapath VisionAV에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath VisionAV 2 페이지. Audio and video capture card
Datapath VisionAV에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)
페이지 인쇄
PACKING LIST
Your packing box should contain the following items:
VisionAV/F
VisionAV/H
Base VisionAV Card
√
√
Fitted to
Audio Module Card
base card
√
Fitted to
1 x Full height bracket
base card
√
One fitted
1 x Half height bracket
X
to each
board
1 x Ribbon Cable 100mm
X
1 x Ribbon Cable 20mm
√
Fitted to
base card
1 x Audio Breakout Cable
√
1 x DVI/VGA Adapter
√
1 x DVI/Component
√
Adapter
1 x DVI/HDMI Adapter
√
Installation CD
√
NOTE:
All plug-in cards are static sensitive and are packed in
antistatic materials. Please keep the card in its
packaging until you are ready to install.
VisionAV/F
HARDWARE INSTALLATION
You are likely to need a flat blade and /or a cross head
screwdriver for the installation of the VisionAV card; it
VisionAV/B
would be useful to have these to hand before you begin.
√
√
Power down the PC (including peripherals), switch off at
√
X
the mains and disconnect all the cables connected to the
computer, noting the positions for accurate
√
Fitted to
X
reconnection. Remove the PC cover.
base card
For the VisionAV/F and VisionAV/B capture cards, locate a
√
vacant PCI Express slot (x4 or higher) on the
√
X
motherboard and remove the blanking plate (retain all
screws).
X
X
If the VisionAV/H is to be installed in a short form
√
X
computer, two locations are required. The VisionAV/H and
√
√
the AM2 (Audio Module) should be installed near to each
√
√
other to enable both cards to be connected together using
the ribbon cable supplied. The AM2 does not require a slot
√
√
on the motherboard.
√
√
If you are in doubt consult your motherboard
documentation to correctly identify a PCI Express slot. If
the card is forced into a 32 or 64 bit PCI or PCI-X slot it will
be irreparably damaged when the system is
powered up and the warranty will be
Reconnect all cables to the PC then connect a DVI cable
(not supplied) distributing the DVI source signal to the
connector on the VisionAV capture card.
A standard definition signal can be connected to the RCA
connector on the VisionAV.
An audio feed can be connected to the Audio Module via
the Audio Breakout Cable.
Insert the Datapath CD into your CD drive, the CD will
autorun and display the following dialogue. If the CD
drive fails to autorun browse the CD and locate and
double click the setup.exe file. Click on Install
Software... and follow the Installation Wizard
Instructions as prompted.
We suggest that you regularly visit the Datapath web site
for information on updated drivers.
www.datapath.co.uk
It is strongly recommended that you read the detailed
help instructions on completion of the installation. Each
help topic may be printed for ease of use.
void.
SOFTWARE INSTALLATION
VisionAV/H
VisionAV/B