Datapath Fx4-SDI 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Datapath Fx4-SDI에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath Fx4-SDI 17 페이지. Multi display controller
Datapath Fx4-SDI에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지)
페이지 인쇄
x-Series Quick Start Guide
STEP 3 CONNECT MAINS CABLE
When the power is switched on the multi-display controller will boot and
the LEDs on the front panel will flash for up to 15 seconds. Should the LED's
continue to flash see the troubleshooting section at the end of this guide.
MOD EL 1 7 5
MOD EL 17 5
MAD E IN E N G L AN D
MAD E IN E N G L A ND
U SB
U SB
1 0 0 - 24 0 V
1 0 0 - 24 0 V
1AMAX 5 0 \ 6 0H z
1 AMAX 5 0 \ 6 0 H z
Switch on
STEP 4 CONNECTING TO A PC
To successfully configure your multi-display controller, firstly install the Wall
Designer application on your PC by downloading the latest version from the
Datapath website www.datapath.co.uk.
4
4
L A N
L A N
When the controller has booted, connect it to your PC using the USB cable
provided. The controller is a plug and play device. Wall Designer will detect it
when the layouts are configured.
The multi-display controller can also be configured via a Network, (see Step 5).
1 A FUS E
1 A FU S E
Connect
Mains Cable
M OD EL 17 5
M O D E L 1 7 5
MA D E I N ENGL AND
MA D E I N E NGL A ND
US B
U SB
10 0 - 2 4 0 V
1AMAX 5 0 \6 0 H z
1 0 0 - 2 4 0 V
1 AMAX 5 0 \6 0 H z
USP Port
1 A F US E
1 A FUS E
5