Datapath iolite 12i 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Datapath iolite 12i에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath iolite 12i 16 페이지.

STEP 4 CONNECTING A CONTROL SCREEN

Your iolite 12i is factory configured to use a control screen connected to the system

internal graphics device. Connect the control screen to one of the two DisplayPorts

or the single HDMI connector on the motherboard panel on the rear of the iolite

12i. A control screen is initially required to set up the system including the operating

system (Windows 10).

If a control screen is unavailable, connect a single video wall display into either the

DisplayPort 1 or HDMI 1 output connector on the rear of the iolite 12i.

DisplayPort 1

STEP 5 POWER UP THE SYSTEM

Connect the power cable into the rear of the iolite 12i (1) then plug into a mains

supply.

Page 4

Control Screen connections

HDMI 1