DUUN PT280 사용 설명서 - 페이지 5

{카테고리_이름} DUUN PT280에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DUUN PT280 18 페이지.

Power transmission shaft

The tractor is disengaged and the handbrake is applied

before the shaft is connected to the tractor's PTO. Max.

PTO speed is 540 r.p.m. Make sure that there is the same

angle in both joints (ie the pin on the tractor is parallel to the

pin on the gearbox). Different angles cause imbalance,

vibrations and increased wear. The power transmission

shafts must always have protective covers that were

originally supplied. Damaged and worn covers must be

replaced immediately!

During raising and lowering of the rod pump, the power

transmission shaft is dismantled.

Safety in case of interruptions and maintenance

Always remember to stop the tractor engine and remove the

ignition key before greasing, adjusting, cleaning or carrying

out repairs. This is to ensure that the tractor does not start

before you have finished.

Crushing hazard for hands and fingers with rotating

parts

Protective covers must always be fitted except for necessary

maintenance and always with the engine stopped. Pay

particular attention to the risk of crushing at points marked for

this.

Work noise

The noise level during use of the propeller depends on the

tractor's general noise level and the acoustics at the

workplace itself. In certain cases this can exceed 85db. In

such cases, the operator must use hearing protection.

Gas hazard!

During the stirring of slurry, gas evolution occurs which in

strong concentrations can be fatal for humans and

animals. Follow the following safety regulations to avoid

injury! - Avoid air flushing during stirring as far as

possible!- Never go down into a slurry container without

being absolutely sure that all gas has been removed (can

be checked with a gas meter that is submerged with a

string) - Never work alone in a slurry container - be at least

two people and use a safety harness - lifeline. - Use a

fresh air mask! -open doors that the gas has low outlets in

the farm building itself during slurry processing.

Check the state of health in the farm building continuously

during slurry handling!

Avoid any unnecessary stay near the slurry chute and

propeller during stirring.