Datapath VSN V3 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} Datapath VSN V3에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath VSN V3 20 페이지. Wall controller

VSN V3 Quick Start Guide

If you chose to have the DDCT configure your wiring, this page will display the

recommended display connections, as shown above. Connect each display to the

corresponding output connector on the rear of the VSN V3 wall controller. The printed

input/output diagram shipped with your VSN V3 wall controller shows where the display

connectors are located on your system. If your VSN V3 wall controller is connected to a

printer, you can print a copy of the wiring diagram using the Print a Wiring Diagram function.

Note: The Datapath Diagnostic Suite must be installed to print a wiring diagram. The suite

can be downloaded from the Datapath website downloads page should it not already be

installed on your system.

To manually select the outputs right click on the display group and select Edit, you can then

select each individual display and allocate your preferred output. Right click on a selected

display to reveal the list of outputs available:

When all outputs have been allocated by either Recommended or Custom click on Finish.

You will then be prompted to save the changes to your video wall and restart your system.

When restarted, the Windows Desktop will be displayed across the wall.

You can access the configuration tool at any time should you wish to make changes.

Right click on the desktop and select Display Driver Configuration Tool from the menu.