2easy DT-597 매뉴얼 - 페이지 3

{카테고리_이름} 2easy DT-597에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2easy DT-597 13 페이지. Door station 2-wire series

Lock Control Jumper : To program electric lock type

Door Station Code DIP : To program address for up to 4 x door stations

T/R+,T/R- : USB-RS485 communication terminal

Main Connect Port : To connect the bus line and electric locks (up to 2)

BUS : Connect to the bus line, no-polarity

PL : Additional power supply for the lock, connect to the power positive(power +)

S1+ : The first lock power (+) output

S2+ : The second lock power(+) output

S - : Lock power(-) output

Door Station Mounting

Steps:

1. Cut out an appropriate size hole, and mount the wall box

2. Adjust the camera angle if needed. Connect the cables. Place name label if required

3. Place the front panel into the mounting box

4. Use the special spanner provided and move it 90

-3-

to lock the front panel

Use a screwdriver to loosen the

screw. Adjust the angle of the

camera and tighten the screw

OPEN

90°