Datapath ALIGO RX100 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Datapath ALIGO RX100에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath ALIGO RX100 7 페이지.
Datapath ALIGO RX100에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

Aligo Quick Start Guide

CONFIGURING ALIGO DEVICES WITHIN AETRIA

Check Device Connections and Network Configuration

First, double check all Aligo devices are connected to the network switch and to their respective video sources

and displays as above before proceeding.

Also ensure that all Aligo devices are on the same Local Area Network (LAN/VLAN) as the Aetria Network

Manager server. This will have been pre-configured by Datapath and should be connected, powered up and

running before going any further.

Once all Aligo devices are connected and powered up, you can verify each device is ready to connect by

checking the link LED is flashing (as per the table on page 7), indicating that it is ready and waiting to be

provisioned within Aetria.

Aligo Device Discovery (Provisioning)

On any machine connected to the Aetria Network, open up a web browser and navigate to the Aetria login

page by following the login instructions. Enter user credentials.

Once within the Aetria Command Center, go to the Manage tab, and select Hardware Configuration.

Then click on Provisioning (highlighted right) to discover the new Aligo sources and add them to the system.

Under the All Devices panel, you will find any new Aligo devices that have been provisioned on the network.

Once a device has been successfully provisioned, the link LED on each device will be in a solid ON state.

From this point on please refer to the Aetria Command Center quick start guide for further details on using

the system.

Aligo Quick Start Guide

Detected

devices

From within Aetria you can check all devices are communicating properly by checking the serial numbers

against the discovered devices.

You have now successfully added your new devices to the Aetria system.

Selected

device

properties