Dataplot EMBLEM EASY Airpress standard 운영 매뉴얼 - 페이지 4

{카테고리_이름} Dataplot EMBLEM EASY Airpress standard에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataplot EMBLEM EASY Airpress standard 20 페이지. Pneumatic eyepress

페이지 인쇄

2 Installation

2.1 Installation Position Requirements

The minimum space recommended must be sufficient to keep that

safety space in all directions for the operator to work properly.

2.2 Pneumatic Installation

The machine has an air inlet valve, type quick acting coupler (ISO 6150-

B standard) 8 mm, located on the back of the machine.

For an optimal operation, the supply of compressed air should be 6 kg/cm

with a pressure gauge that customer's will have installed on its compressor.

2.3 Transport

If it is necessary to transport the machine again after its installation and the customer does not

have the original packaging, we advice to use a reinforced package (wood or cardboard).

2.4 And Holding The Box Firmly

Before any operation with the equipment, the machine must be properly fixed to the bench

(from the customer) with 4xM8 screws (8.8 quality), washers and self-locking nuts.

2.5 Learning Instructions

The following set of instructions and warnings about EMBLEM Easy

AIRPRESS Standard should always be taken in account:

Before connecting the machine to the compressor or to customer's

pneumatic installation, it should be place on its permanent location.

• The cleaning, handling or replacement of parts should

always be made with the air inlet valve shut.

• Do not remove from the machine the safety devices, stickers

or warning signs that point out dangerous areas.

• The machine has an air inlet valve to manually open and close the air supply to

the pneumatic cylinder "F" (Fig. 1); When the machine is not in use, it should be

shut (see Fig. 5), to avoid accidents when use by a third party. We also suggest

disconnecting the hosepipe from the compressor for safety reasons.

(3)

Page - 4 -

CLOSE position

Fig. 5

, adjusted

OPEN position

Fig. 6