Dataprobe 4P-MAS 빠른 시작 매뉴얼

{카테고리_이름} Dataprobe 4P-MAS에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataprobe 4P-MAS 9 페이지. 4 position menu activated switch

INTRODUCTION

The 4 Position Code Activated Switch,

switched to any of four RS-232 devices, designated A through D. Typically, the 4P-MAS is used to

allow one modem to access the configuration or out-of-band management ports of four remote devices

(see Figure 1A). Three modes of operation allow the selection of the port to be connected.

Menu Selection

The 4P-MAS selects the port to connect to the master based on menu selections.

The menu system allows convenient naming of each port, and setup of all 4P-MAS

parameters.

Lead Control

This option allows any of the four ports can access the master port by raising its

Request To Send (RTS) or Data Terminal Ready (DTR) control lead. This capability is

in addition to the menu selection as described above.

Manual Control

A front panel push-button allows local control of port selection.

There are four LED's on the front of the 4P-MAS to indicate which port is connected to the master.

There are four DB25S female connectors on the rear panel for the switched ports, (designated A-D) and

one DB25P male connector for the Master Port. The 4P-MAS also supports an internal modem option.

Dataprobe supplies modems from 2400 bps to 33.6 Kbps. This modem can be factory or field installed.

Figure 1 illustrates a typical system using the 4P-MAS.

REF: CAS\4P-MAS_V980326R.DOC

Model 4P-MAS

Internal or

External

Modem

11 Park Place / Paramus, New Jersey 07652

TEL: 201-967-9300

Website: www. dataprobe.com Email: [email protected]

4 Position Menu Activated Switch

Model 4P-MAS

allows one master RS-232 port to be selectively

To 4 DTEs

Master

Port

To DCE

Technical Support Hotline: (201) 967-8788

FAX: 201-967-9090