Dataprobe iBoot 매뉴얼 - 페이지 11

{카테고리_이름} Dataprobe iBoot에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataprobe iBoot 20 페이지. Web enabled remote power control
Dataprobe iBoot에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄

1. Setting Ip Address

iBoot Ver 1.5

4. Setting the IP address using ARP / Ping

To set the IP address using ARP, connect the ethernet

connection to your network and apply power to iBoot. Using ARP

you use a computer to set the IP address. The IP address

assigned to iBoot must be use the same network segment as the

computer assigning the address. ARP does not work across

routed or switched networks.

To set the IP address using ARP, the hardware (MAC) address

must be known. This address is located on the bottom of the

unit. The syntax for the MAC address is: nn-nn-nn-nn-nn-nn

Windows (98 and Later)

1. Open a DOS window.

2. Type the following command:

arp -s <IP Address> <MAC Address>

Where <IP Address> is the desired IP address (in dotted

decimal) for the iBoot and the <MAC address> is the MAC

Address of the iBoot. The MAC Address of the iBoot is

located on bottom of the unit.

Example: arp -s 63.211.86.165 00-50-c2-05-01-c1 <enter>

3. Ping the iBoot to program the IP address into the iBoot.

Type: ping <IP Address>

If the ping command returns "host not responding" 4 times

then the address has not been programmed properly, or the

IP or MAC Address is incorrect. In either case redo step 2.

If the problem persists, contact the Dataprobe Tech Support

Hot Line.

4. Delete the entry from the ARP cache by typing:

arp -d <IP Address>

5. Ping the iBoot to confirm that it has been programmed.

If the iBoot fails to respond, repeat steps 2-4 above. If the

problem persists contact the Dataprobe support hotline.

Unix, Linux, MAC and others

Consult your systems administrator for information on setting an

IP Address. The unit should be pinged after the IP Address has

been set to confirm proper operation.

|- new IP addr. --| |----- MAC addr. ----|

Page 11