Dataprobe iBoot 매뉴얼 - 페이지 14

{카테고리_이름} Dataprobe iBoot에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataprobe iBoot 20 페이지. Web enabled remote power control
Dataprobe iBoot에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄

1. Setting Ip Address

iBoot Ver 1.5

Setup Page

The setup page consists of several sections. Each time a setting

is changed click on the Apply button for that section to save the

changes in iBoot.

network manager for more details. This will be automatically set if using DHCP

HTTP Port: This setting is used to allow access to iBoot on a port other than the

Web standard Port 80. If the port is changed, you will need to identify the port

number when you enter iBoot's IP address into your browser: if the new port is

9100 then use http://192.168.1.254:9100 to access iBoot.

After changing the port, a reboot is

necessary. Consult your Network

Administrator for available port

assignments. Click on the Reboot button

at the top of the page to install the new

port.

Page 14

Device Name: Set a 20

Character name to be

displayed on the top of

each web page.

Cycle Time: 0 to 999

seconds power cycle time.

This is the length of time

the power will be off during

a reboot. You can also

cycle power on for this

time.

IP address: Enter either a

new IP address, or address

0.0.0.0 to enable Automatic

IP addressing via DHCP.

Once you click Apply for

this section, also click the

Reboot button that will

appear at the top of the

page. The new IP address

will not take effect until the

unit is rebooted.

Subnet Mask: Change if

required. Consult your

network manager for more

details. This will be

automatically set if using

DHCP

Gateway: Change if

required. Consult your