Dataprobe IP-2810 매뉴얼 - 페이지 7

{카테고리_이름} Dataprobe IP-2810에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataprobe IP-2810 13 페이지. Dual input web controlled power switches

iP-28xx

Select S to access the setup Menu

Setup

1. Circuit Names

3. Password

5. Baud Rate

X. Return to the Main Menu

Enter > x

Circuit Names

Each circuit can be identified with a 20-character name for easy identification. Select 1 from the Setup menu. A list of all

eight circuits is displayed with the option to change any circuit name. These names are used in both the telnet screens and

web page.

Location Name

Each power strip can be identified by a Location name that appears at the top of each telnet and web page. Select 3 from the

Setup Menu to set the Location, up to 20 characters.

Password

This selection offers an opportunity to change the password required for Telnet and Web Browser Access. To change the

password, Select 4 from the Setup Menu. The password can be up to 8 characters and is case sensitive. Enter the current

password, followed by the new password, then confirm the new password. Please remember your password. If you forget

your password, contact Dataprobe Tech Support 201-967-8788 or [email protected]

Cycle Time

This feature selects the time in seconds for a Cycle command for any of the outlets. This would typically be used to support

power-off-reset for power control applications. To set the cycle time, select 5 from the Setup Menu. The Cycle Time can be

from 01 to 99 seconds. Use Leading zeros when entering 01 to 09 seconds.

Baud Rate

Select 5 to cycle though the available choices for baud rate (2400, 9600, 19200)

- Location Name

- 10

- 19200

Page 7