Dataprobe IP-2810-M 매뉴얼 - 페이지 4

{카테고리_이름} Dataprobe IP-2810-M에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataprobe IP-2810-M 13 페이지. Dual input web controlled power switches

페이지 인쇄

iP-28xx

Serial Port pinout:

Pin No

Description

Data Carrier Detect

Receive Data

Transmit Data

Data Terminal Ready

Signal Ground

Data Set Ready

Request to Send

Clear to Send

Ring Indicator

Modem Connection * for models with internal modem *

For units with internal modems, an D9 to RJ11 adaptor is used. This is included with the unit.

Connection Diagrams

iP-2815

iP-2815-M

A/C Power Connections

The iP-2820 provides two linecords for connection to two 20 Amp 115VAC services (NEMA 5-20P). The total maximum

current load for each group of four outlets (1-4 and 5-8) cannot exceed 16 Amps.

The iP-2815 provides two linecords for connection to two 15 Amp 115VAC service (NEAM 5-15P). The total maximum current

load for each group of four outlets (1-4 and 5-8) cannot exceed 12 Amps.

The iP-2810 is for international applications and can be set for use on 115V or 230VAC. The iP-2810 provides two IEC 320

style universal inlet for connecting a detachable power cord. Two standard IEC to NEMA 5-15 cord sets are supplied with the

unit for use on 15 Amp 115VAC service. The total maximum current load for each group of four outlets (1-4 and 5-8) cannot

exceed 12 Amps at 115VAC or 10 Amps when used at 230VAC.

Note: Linecord marked 1-4 is required for the remote control operation of the unit. If Linecord 1 is disconnected all LEDs and

communications will not function and all outlets powered by linecord 5-8 will turn On.

Crossover

Cable

D9-RJ Adpater

# 1940149

External

Modem

Straight

Cable

Direct Connect

to Terminal

Emulation

Dial-up

Page 4

Dial-up

Dial-up to

computers running

Dial-up Networking

Telnet and/or Web