Dataprobe iBootBar 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Dataprobe iBootBar에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataprobe iBootBar 3 페이지.

Setting the IP address using CLI

Connect to the iBootBar for initial setup using the Command Line Interface (CLI) to set the IP Address. You will need to be on the

same local subnet (192.168.0.xxx) to perform the initial configuration.

These are the basic commands to set the network parameters. After setting these parameters, the iBootBar will need to be rebooted

for the settings to take effect. Any command that requires rebooting of the iBootBar will provide a prompt to do so. All commands

may be entered as required before rebooting.

Example: Telnet to default IP address 192.168.0.254

iBootBar Rev 1.5a.276

User Name:

admin

Password:

*****

iBootBar > set ipaddress 192.168.1.3

Reboot Required!

iBootBar > set subnet 255.255.255.0

Reboot Required!

iBootBar > set gateway 192.168.1.7

Reboot Required!

iBootBar > reboot

IP Address = 192.168.1.3

Serial Port

The iBootBar has a 9 pin D subminiature connector for RS-232

serial control. The connector is configured as DCE for direct

connection to a laptop or other terminal device. Default serial

parameters are 115,200 bps, 8 data, no parity, 1 stop bit

(115200,8,n,1). Flow control is not used.

Web Browser Control

The iBootBar web interface provides the easiest

means of operating the outlets and monitoring the

current status of the units. One or more outlets can

be simultaneously controlled with a few mouse clicks.

In cluster configurations, all 128 outlets can be

managed from the web pages.

To Control any of the outlets, Click on the checkbox

next to one or more outlets, then click the desired

new status, On Off or Cycle.

When Cycle is selected, the outlet(s) will cycle for

the amount of time set in the Cycle box. When mor

e than one outlet is controlled to turn on, there will

be a delay between outlets turning on, as set by the

Delay box.

iBootBar Quick Start

Additional Useful CLI Commands

get outlets

set outlet <1-8> <on/off/cycle>

get network

help

help <network/outlets/device/users/groups...>

logout

See all the CLI Commands in the complete iBootBar

manual, available at

Pin No

dataprobe.com/support

Description

Receive Data

Transmit Data

Signal Ground

V150715E