Dataprobe iBoot 매뉴얼 - 페이지 12
{카테고리_이름} Dataprobe iBoot에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataprobe iBoot 20 페이지. Web enabled remote power control
Dataprobe iBoot에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)
페이지 인쇄
iBoot Ver 1.5
Page 12
Web Browser Operation
Password Protection
iBoot uses two passwords, one for normal use and one that also
provides access to the setup functions. From the factory, both
passwords are the same. (PASS)
Open your browser and enter the IP address of iBoot into the
address bar. If your have changed the IP address by any of the
methods listed above, enter that address, otherwise, use the
default IP address 192.168.1.254
Enter the default password PASS, or your password if it has
been changed. A Username is not required. When the proper
password is received the Control and Status Page is displayed.
Control and Status Page
Once the password is entered, the following page is displayed.
(Only one person can be connected to the iBoot at a time.)
Device Name
Power Status
Action Buttons
Power Cycle Time
Click to
Refresh Status
Click for Logout
Click for Setup
(only seen if the Setup
Password is used)
To control the power, click on the appropriate button. During
power cycling, the Power Status bar will indicate the temporary
status, with a blue background. Once the cycle is complete, the
status bar will revert to its original condition. To abort a power