AGRI-COVER SNOWSPORT 180 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} AGRI-COVER SNOWSPORT 180에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGRI-COVER SNOWSPORT 180 12 페이지. Utility plow

2. ASSEMBLING SNOWPLOW (Continued)

F. Insert (2) square nuts with flat side facing up in top channel of blade end and align with

slide hinge top holes.

G. Insert 3/8" x 3/4" bolts with 3/4" washers through holes in slide hinge and thread into

nuts inside channel.

H. Ensure both lower holes in slide hinge are still aligned with factory marks on blade,

then tighten (2) top bolts.

I. Repeat Steps 2E-2H for opposite end.

(2) Square nuts

flat side up

J. With rubber blade centered, use both lower holes in each slide hinge as guide to drill

5/16" holes through first layer of aluminum and partially into rubber. Then turn 3/8" x 1"

self-threading bolt into each hole and tighten to secure each hinge.

K. At factory mark near each end of blade, drill 5/16" hole through first layer of aluminum

and partially into rubber. Turn 3/8" x 1" self-threading bolt into hole and tighten.

3/8" x 3/4" Bolt

3/4" Washer

These holes in hinges line up with factory

marks on blade (to set hinges 14-1/2" apart)

Slide hinge

2nd

1st

3/8" x 1" Self-

threading bolts