Dux Radiant 135AN 소유자 매뉴얼 - 페이지 10
{카테고리_이름} Dux Radiant 135AN에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dux Radiant 135AN 18 페이지. Gas storage water heater
페이지 인쇄
DO NOT operate with panels or covers removed from the appliance.
FILLING THE WATER HEATER
Open all hot water taps. Open stop cock at the cold water inlet and allow water heater to
fill until water flows through the system. Close each hot water tap after the air is expelled
from its line.
LIGHTING THE WATER HEATER
The water heater must be filled with water before lighting.
Instructions for lighting
procedure are on the inside of the access cover and shown in Figure 4.
The access cover is removed by lifting the cover upwards and away from the water heater.
The unit is fitted with a thermostat that incorporates a Thermal Overload Safety Cut-Out. In
the event of thermostat failure, the Safety Cut-Out will automatically and permanently cut
off the supply of gas to the burner. If this happens, your heater will not light and you should
call your local Dux agent.
FITTING OF PLUMBING INSULATION CAPS
To ensure optimum operating efficiency of the water heater the two Plumbing Insulation
Caps supplied with the water heater must be fitted to the two brass plugs (also provided
with the water heater) used to seal the unused hot and cold water connection fittings on
these dual handed plumbing featured models. Refer Figure 3 below:
10