Aus Electronics Direct HDEX0027M1 사용자 설명서 - 페이지 4
{카테고리_이름} Aus Electronics Direct HDEX0027M1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aus Electronics Direct HDEX0027M1 6 페이지. 4k 60hz hdmi extender bycat
페이지 인쇄Note: to follow above connecting diagram shows, you can connect HD
Signal source → HDMI Extender Transmitter → HDMI Extender Receiver →
Display→IR Transmitter→IR Receiver-Power
1. Connect the HDMI IN Port of the TX to the HDMI output port of
signal source/PC over one HDMI cable.
2.Connect the HDMI OUT Port of the RX to the HDMI input port of
display device over one HDMI cable.
3. To use one Ethernet cable to connect the CAT Output port of TX with the
CAT IN Port of RX, Ethernet cable max supports to 100m. You can do cascade link
by using Ethernet cable to connect the CAT Out port of the RX with the CAT IN
Port of the next level RX.
4.To connect the power adaptor to the TX or RX for supply the power.
5. IR Transmitter and Receiver to connect to matched IR-IN/IR-OUT port.
IR Extend
1. IR Extend is used for using IR remote to do distance control to
the peripheral device.
2. To check if the working frequency of the IR remote is under the
range of the 30-50HZ.
3. To point the IR Transmitter head at the peripheral device location.
4. At One to Many mode, the IR can be only used for the first level TX and RX
data transmission rather than the latter level.
5. TX IR and RX IR Pins Diagram：