Auscrown Y028NGWF 설치 및 운영 지침 매뉴얼 - 페이지 4
{카테고리_이름} Auscrown Y028NGWF에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Auscrown Y028NGWF 11 페이지. Duckbill stockpot burner with flame failure safety device
페이지 인쇄Revision 2 November 2012
PREPARE TO ASSEMBLE THE APPLIANCE
Check for damage on the appliance. If damage occurs, please contact Austcrown or your dealer. Do not use
a damaged appliance.
WARNING! It may hazardous to attempt to use a damaged appliance.
Positioning the Appliance
Only use the appliance in well ventilated areas.
CLEARANCE: The appliance must be sited with at least a 1000 mm gap between both sides, from the front
and the rear of the appliance and at least 2700 mm from the trivet of the appliance and any combustible or
non-combustible materials above the appliance.
When the appliance is assembled abutting a side or rear wall, the wall must be of non-combustible material,
e.g. ceramic tiles. If surrounding walls are constructed with a combustible material, refer AS/NZS5601.1 for
information on the clearance required.
The appliance must be used on a level, stable, non-flammable surface when in use. This appliance is
intended for commercial use only.
It is important that the ventilation openings of the appliance are not obstructed. The appliance should be
protected from direct draughts.
The appliance should not be positioned or protected against direct penetration by any trickling water (e.g.
rain).
If the appliance is installed outdoors, a proper shelter with good ventilation should be used to protect the
appliance from draughts and rain. Some examples of shelters are shown below,
IMPORTANT: The dimension and building materials of the shelter must meet the requirements mentioned
above, or contact your gas filter / local Gas Authority for information on clearances and material required
EXAMPLE 1