DV Mark DV 403 소유자 매뉴얼 - 페이지 5
{카테고리_이름} DV Mark DV 403에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DV Mark DV 403 13 페이지.
페이지 인쇄11) STANDBY Before powering on, make sure this switch is in standby position. When you turn on the power, the microcontroller waits for
the tubes to heat up before turning on the plate voltage. The "power on" LED will flash for 30 seconds before the amp is ready. When the LED
stops blinking, flip the standby switch to the ON position. Between sets or whenever you're on a break from playing, put the amp in standby
position (down).
12) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be
connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where
they have been sold, and are factory preset to that country's voltage. So make sure you're sending the correct voltage to your amp before you
connect it to AC power. Follow the procedure described in the STANDBY section above (12) before powering up your amp.
DV 403 CPC
BASS
CH1
6
INPUT
GAIN
2
3
-6 dB
1
0 dB
MIDDLE
HIGH
BASS
CH2
6
7
8
MASTER
PRESENCE
GAIN
4
5
3
MIDDLE
HIGH
BASS
CH3
6
7
8
MASTER
GAIN
4
3
MIDDLE
HIGH
SOLO
7
8
9
MASTER
CONTINUOUS
STANDBY
ON
POWER CONTROL
10
4
1W
40W
11
12
PENTODE
5