DV Mark Little 40 L34 소유자 매뉴얼 - 페이지 5
{카테고리_이름} DV Mark Little 40 L34에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DV Mark Little 40 L34 13 페이지.
페이지 인쇄the tubes to heat up before turning on the plate voltage. The "power on" LED will flash for 30 seconds before the amp is ready. When the LED
stops blinking, flip the standby switch to the ON position. Between sets or whenever you're on a break from playing, put the amp in standby
position (down).
12) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be
connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where
they have been sold, and are factory preset to that country's voltage. So make sure you're sending the correct voltage to your amp before you
connect it to AC power. Follow the procedure described in the STANDBY section above (11) before powering up your amp.
3
2
10
11
1
12
4
5
6
7
8
9
5