4ms PEG 사용자 설명서 - 페이지 5
{카테고리_이름} 4ms PEG에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4ms PEG 12 페이지. Pingable envelope generator, eurorack module
페이지 인쇄Ping Divider/Multiplier
Once a ping time has been established, you can then divide or multiply it from 1/8th the speed to 8 times the
speed, in whole number increments. The resulting clock is called the "Divided/Multiplied Ping Clock", or just
"Ping Clock" for short.
The Ping button flashes to the rate of the Divided/Multiplied Ping Clock
•
The Ping Div/Mult knob sets the amount of multiplication or division of the incoming ping time, along with
•
any CV that's applied to the Div jack (the knob sets the offset for the CV)
Changing the Div/Mult amount in the middle of an envelope will have no effect until a ping clock is
•
received, or the divided ping clock timing period renews, or the envelope starts a new rise/fall segment.
See Figure 1A.
Giving a pulse to the QNT jack will force an update of the div/mult amount immediately (in the middle of
•
a curve if necessary). If you hold a gate high on the QNT jack, the div/mult amount will track the CV
(glitchy envelope shapes can be obtained this way!) See Figure 1B.
When the Div/Mult amount changes, the PEG has to compensate the envelope in order to maintain
•
timing. A partial envelope may be generated after the div/mult amount changes in order to insure that
subsequent envelopes are synced to the ping clock. See Figure 2.
Figure 1A: Changing Div/Mult (with no gate on QNT)
Notice the envelopes always start on the ping clock's
rising edge
Page 5
Figure 2: Changing Div/Mult causes "catchup" partial
envelope. Change occurred from x4 to /4, in the
middle of second "high" portion of the ping clock.
New envelope re-syncs abruptly on the following
ping clock.
Figure 1B: Changing Div/Mult while holding a gate
high on QNT
Slope of envelope changes each time the Div/Mult
CV/knob moves to a new div amount