AUSnew G3 RM138-51 사용 설명서 - 페이지 3

{카테고리_이름} AUSnew G3 RM138-51에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AUSnew G3 RM138-51 4 페이지. Aluminium wheelchair

Congratulations on the purchase of your new G3 Aluminium Wheelchair.

Equipped with several features and accessory choices you are sure to enjoy

the benefits of this chair.

Please follow these simple steps to assemble your wheelchair –

1. With the chair upright, push down on the sides of the seat until it

clamps into position.

2. Lift backrest up to click into position. Depress black latch to fold.

3. Fit legrests (both left and right) into the fitting from an outward angle

and turning inward until it locks into position. Footplate height can

be adjusted using the allen key provided. Loosen the footplate and

select the desired height, retighten to secure. Elevating legrest are

available for this chair and fit into place the same way as the

standard legrests. To adjust loosen the screw, select the desired

angle and retighten.

4. G3 Self Propel Wheelchairs have a quick release 24" wheel. To

release push the centre button on the axle and pull out. To reinstate

locate the axle back into bracket on the frame. Ensure it is fully

engaged before using the chair.

5. Armrests flip back and are removeable. To release the armrest push

the clip at the front and flip back, to re-instate clip back into the front

bracket and ensure it locks into place. To remove armrest push clip at

the front and pull lever at the rear then lift armrest up armrest.

Again ensure clipped back in securely when replacing.

6. Care-assist hand brake , (where fitted) provides added security to the

person pushing the chair. When the wheelchair is stationary, the

hand brake at the wheel should be applied for added security. To

apply push forward, to release pull back.

Assembly / Adjustment