DV8 OFFROAD RBJL-11 설치 매뉴얼
{카테고리_이름} DV8 OFFROAD RBJL-11에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DV8 OFFROAD RBJL-11 13 페이지. Fs-15 rear bumper 18+ jeep wrangler jl
페이지 인쇄FS-15 REAR BUMPER
18+ JEEP WRANGLER JL
RBJL-11
TOOLS
REQUIRED
- Rubber mallet
- 22g wire (10-14") and connectors
(2-6pcs)
- Zip ties
- Electrical tape/wire loom
- 7, 8, 16, 18, 21mm Sockets
- 10, 17, 18, 21mm Wrench
- #4, #6 Allen Bit
- Wire Cutters/Crimpers
- Blade or Scissors
- Phillips Head Screw Driver
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
Before you install this kit —
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner's manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
SKILL
LEVEL
- Novice, Intermediate
- 2 persons
Little skill level required, however,
additional help is required for
removal and installation of
bumpers.
Read and understand all
PRODUCT
INSTALLATION
TIME
- 3 Hours
Time to install this should only
take about three hours
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
NEED HELP?
MANUAL
REQUIRED
855-680-9595