Agri-Fab 175 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Agri-Fab 175에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 175 12 페이지. Agri-fab 175 broadcast spreader owner's manual
페이지 인쇄
21. Place the adjustable stop into the "ON" end of the slot
in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a 5/16"
flat washer and the nylon wing nut. See figure 12.
NYLON
WING NUT
5/16" FLAT
WASHER
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
FIGure 12
ADJUSTABLE
STOP
7
22. Position the flow control mounting bracket.
(Figure 13).
a. Push on flow control arm until it locks in "OFF"
position.
b. Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
c. Snug the 1/4" lock nuts just enough to hold flow
control mounting bracket in place.
d. Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, it may be
closed too far at "OFF". Adjust position of flow control
mounting bracket until closure plate will open about
half way at "5" and still close when arm is locked
in "OFF". Tighten 1/4" lock nuts.
FIGure 13
AJDUSTABLE
STOP
SETTING "5"