DataStor DT51UWS-P 설치 매뉴얼

{카테고리_이름} DataStor DT51UWS-P에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DataStor DT51UWS-P 2 페이지. Scsi iii 68pin removable tray & frame, plastic

페이지 인쇄

Installation Guide

SCSI III 68pin Removable Tray & Frame, Plastic

Packing List - Check Contents Prior To Installation:

1) 1 - 5.25" Plastic 68pin Frame

2) 1 - 3.5" Plastic 68pin Tray

3) 1 - Screw/Key Pack

3) 1 - Installation Guide

Electrostatic Discharge

Many components on your hard disk are susceptible to electrostatic

discharge. To prevent damage to these components, take careful

precautions before handling your hard disk.

Remove the Casing for your Tower/Enclosure

1. Unplug the computer, as well as all peripheral devices and cables.

2. Referring to the owner's manual for your computer or enclosure,

remove the outer casing.

3. Referring to the owner's manual for your computer or enclosure,

remove any front panel or bezel on the 5.25" bay you plan on installing

your tray & frame in.

Install the Frame

1. Place the Frame into the 5.25" Bay with the backplane of the Frame

toward the rear of the bay. To determine which side of your frame is

the top, view the frame from the back (Figure 2) if the fan is on the

left side, you are holding the frame right side up.

2. Line up the four bracket holes in the frame with the corresponding

holes in your 5.25" bay. Using the screws which can be found inside

of your tray (along with the keys to the tray lock), fasten the frame

into the bay.

3. With the frame securly fastened, slide the tray into the

frame to ensure that the tray fits snugly but smoothly

into the frame. Be sure that the tray is right side up by

viewing the front (handle side) of the tray. If the tray is

right side up, the lock will be visible on the right side of

the tray. As the tray is slid into the frame, apply even

pressure to both sides of the tray to ensure a proper

connection.

4. Remove the tray by gently lifting on the FORCE-LESS

handle until the tray is dislodged from the frame. Then,

gently pull on the tray with the handle until the tray is

completely removed from the frame assembly.

Make Wire Connections Between Frame and Enclosure

1. With the frame mounted in the enclosure, turn the

enclosure so that you have a clear view of the

backplane of the frame. Connect the 68 pin HDD

controller cable and the power cable.

2. Referring to Figure 3, as well as the documentation

provided with your enclosure, connect the SCSI ID

cables to the five connectors as shown in Figure 3.

Installation Guide - DataTrans 68 pin Plastic Removable Tray&Frame, Rev 1.0 - July 1998 - P/N DT51UWS-P

Figure 3

(MORE)

Figure 1

Figure 2

Top

Bottom

68 pin HDD

Connector

Controller

Power